PMDX Forum
General Category => SmartBOB controllers and dedicated accessories => Topic started by: RhoTu on December 01, 2017, 06:07:30 PM
-
Pmdx 411, mach4 and gecko g540 on a lathe
In my original profile I have motor3 used as an indexer and it works well. I would like to use motor 3 as a spindle at times. Setting up a new profile that has ob1 paired to motor 3 and spindle page selected as step/dir ob1. What pmdx plugin spindle settings do I select?
Would I have to make wiring changes to use it as a spindle for the new profile (Please say no!)?
TIA
RT
-
Search the PMDX plug-in release notes for "out of band" (http://www.pmdx.com/PMDX-SmartBOB-USB-Plug-In then look for link for most recent release notes, or if you have the plug-in installed, look in Mach4Hobby\Plugins\PMDX-SmartBOB-USB). You will see that it does not support out-of-band motors.
They do have a spindle speed mode called "step pulse frequency". That might work.