1
General Discussion / Replacing control boards, XP to Windows 10. Mach3 to Mach4.
« on: August 03, 2020, 05:15:41 PM »
Hello!
I'm pretty much a "noob" in this CNC world and was hoping I could find some help here. I've recently came into the possession of a built DIY CNC and it's using this board: https://www.steppermotorcanada.ca/db25-1205f.pdf
Though I'm wanting to update to Mach4 to be able to use a computer I plan to 3D model on using Fusion 360 which is Windows 10. The CNC came with an uninstalled SmartBOB-IsoUSB PMDX-424 board. The drivers used are: https://www.makerlab-electronics.com/product/stepper-motor-driver-dq860ma/
Is this possible? I wasn't able to find a wiring diagram, maybe it's supposed to be straight forward.. hah.
I'm pretty much a "noob" in this CNC world and was hoping I could find some help here. I've recently came into the possession of a built DIY CNC and it's using this board: https://www.steppermotorcanada.ca/db25-1205f.pdf
Though I'm wanting to update to Mach4 to be able to use a computer I plan to 3D model on using Fusion 360 which is Windows 10. The CNC came with an uninstalled SmartBOB-IsoUSB PMDX-424 board. The drivers used are: https://www.makerlab-electronics.com/product/stepper-motor-driver-dq860ma/
Is this possible? I wasn't able to find a wiring diagram, maybe it's supposed to be straight forward.. hah.