PMDX Forum

General Category => SmartBOB controllers and dedicated accessories => Topic started by: hernandd58 on May 07, 2016, 07:26:32 PM

Title: Error Message for Limit switches
Post by: hernandd58 on May 07, 2016, 07:26:32 PM

Why do i get this message every time i start mach 4
Mach halted due to Y-- LIMIT switch Active.  This message does not seen to do anything but it is there every time i start Mach 4.

Title: Re: Error Message for Limit switches
Post by: Bob at PMDX on May 08, 2016, 11:24:22 PM

I'll look at this when I get the plug-in debug log from this thread: http://www.pmdx.com/PMDX-Forums/index.php?topic=268.0

Bob

Title: Re: Error Message for Limit switches
Post by: Bob at PMDX on May 23, 2016, 12:00:48 PM

Just to close out this thread - see this response in the other thread referenced above:

http://www.pmdx.com/PMDX-Forums/index.php?topic=268.msg1094#msg1094