1
General Discussion / Interfacing PMDX 424 to Servos Feedback Signals
« on: October 17, 2016, 07:27:30 PM »
Never used servos before and would like to give them a go.
Question: I am making CNC mill conversion using servos made by Teknic. Can the 424 interface with this type of servo motor? I understand there is an error feed back wire, can the 424 deal with this type of input? Does using this type of servo require scripting to utilize this feedback signal?
Scott
Question: I am making CNC mill conversion using servos made by Teknic. Can the 424 interface with this type of servo motor? I understand there is an error feed back wire, can the 424 deal with this type of input? Does using this type of servo require scripting to utilize this feedback signal?
Scott