Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - kane14109

Pages: [1]
1
SmartBOB controllers and dedicated accessories / 424 board and E-Stop
« on: May 20, 2016, 08:57:22 PM »
Just got my board today and have it all wired up and connected to the computer.   Running Mach4 I can not enable the system.  I get an error message - EStop Active not allowed.  I have tried with the J14 jumped and not jumpered. (plugging in and unplugging the termination plug).  Suggestion are needed.   Anxious to get resolved.   Thanks. 

Pages: [1]