« previous next »
Pages: [1]

Author Topic: Error Message for Limit switches  (Read 3419 times)

hernandd58

  • Posts: 22
    • View Profile
Error Message for Limit switches
« on: May 07, 2016, 07:26:32 PM »
Why do i get this message every time i start mach 4
Mach halted due to Y-- LIMIT switch Active.  This message does not seen to do anything but it is there every time i start Mach 4.
Logged

Bob at PMDX

  • Administrator
  • Posts: 368
    • View Profile
    • PMDX
Re: Error Message for Limit switches
« Reply #1 on: May 08, 2016, 11:24:22 PM »
I'll look at this when I get the plug-in debug log from this thread: http://www.pmdx.com/PMDX-Forums/index.php?topic=268.0

Bob
Logged
Engineering Hell: Everything's right and nothing works.
Bob's Corollary: If everything's right and nothing works, double check your assumptions.

Bob at PMDX

  • Administrator
  • Posts: 368
    • View Profile
    • PMDX
Re: Error Message for Limit switches
« Reply #2 on: May 23, 2016, 12:00:48 PM »
Just to close out this thread - see this response in the other thread referenced above:

http://www.pmdx.com/PMDX-Forums/index.php?topic=268.msg1094#msg1094
Logged
Engineering Hell: Everything's right and nothing works.
Bob's Corollary: If everything's right and nothing works, double check your assumptions.
Pages: [1]
« previous next »