Hi,
I'm building a CNC Router with 2 X motors on the X axis and I was hoping to either use Motors 0 (Z) + 1 (Y) + 3a & 3b (X) or 0 (Z) + 1 (Y) + 2 (X) + 3 (X') and use Mach4 to so the slaving part but I just realized that in either case the PMDX 424 does not support different sensors for homing separately X and X'
Reading the forum I understand this was a planned feature back in 2016 - is there an update on when will this be supported ?
And should one wire it's CNC rather with
Motors 0 (Z) + 1 (Y) + 3a & 3b (X)
or
0 (Z) + 1 (Y) + 2 (X) + 3 (X')
in order to use this feature down the road ?
Pierre