1
SmartBOB controllers and dedicated accessories / PMDX424 - Lathe threading - Mach4
« on: January 17, 2018, 11:07:28 PM »
Hi folks,
I've read all I could find regarding your threading/sync methods.
Can you tell me how you handle the pullout of the tool at the end of the thread ?
Does the Z maintain the constant feed rate during the retraction ?
Thanks,
Tripp
I've read all I could find regarding your threading/sync methods.
Can you tell me how you handle the pullout of the tool at the end of the thread ?
Does the Z maintain the constant feed rate during the retraction ?
Thanks,
Tripp