Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - onthemarc

Pages: [1]
1
I did have the spindle in motor config set to port 1 pin 16.
I turned that off and I heard the relay click.
tried M3  and nothing M5 and I had a light at J6 pin 16
I unchecked the active low and it works fine now
Thanks for your help

2
I need help to get my K1 relay to work. I am trying to power my router on/off
I have a PMDX 126 BOB with ESS running Mach3
I'm not sure if the problem is in a mach3 setting or a BOB or ESS setting.
My CNC router is up and running so I assume my charge pump is working fine.
I have tried the following.
I am running in Jumbo mode. Dip switch settings
1-open
2-closed
3-closed
4-closed
5-open
6-open
7-closed
8-closed
JP1 and JP2 both in multimode.  I have 110volts to one side of K1 relay but no power out and no LED next to the relay.
Inn Mach 3 config (spindle setup) relay control: disable relay control is unchecked and M3 output#2
Config output signals:  outputt#2 enabled – port1 – pin 16 --active low (red X)
Mach 3 is adding M3 and M5 to the G-code  and I try the MDI input M3  I have “No Joy”
I have tried meany other settings without success.
What should I try next?
Thanks Onthemarc

Pages: [1]