PMDX Forum
General Category => Cables, connectors, switches, contactors, sensors and other items => Topic started by: megaplow on June 13, 2021, 06:11:27 PM
-
Hey All,
I am moving from Mach3 to March4 and swapping out the stock controller for a PMDX-126 and ESS. My limit switches and motors are working, now it is time for the spindle. I would like to use the onboard relays to denote direction. I believe my wiring is correct, but I need some help with the configuration. Looking at the setup below, can you please tell me how to configure the ESS and Mach4?
JP1 - Multimode
K1 Com -> VFD - DCM
K1 N/O -> VFD - M1
JP2 - Multimode
K2 Com -> VFD - DCM
K2 N/O -> VFD - M2
J6 - 1 = Port 1 Pin 1 -> VFD - ACM
J6 - 16 = Port 1 Pin 16 -> VFD - AVI
-
Forgot to mention the use for the wiring...
JP1 - Multimode
K1 Com --> VFD - DCM -- Input signal
K1 N/O --> VFD - M1 --> ESS - Clockwise
JP2 - Multimode
K2 Com --> VFD - DCM --> Input Signal
K2 N/O --> VFD - M2 --> ESS Counter Clockwise
J6 - 1 = Port 1 Pin 1 --> VFD - ACM --> ESS - Spindle COM
J6 - 16 = Port 1 Pin 16 --> VFD - AVI --> ESS - Spindle PWM
-
What was the solution?