PMDX Forum
General Category => SmartBOB controllers and dedicated accessories => Topic started by: beerus on February 21, 2016, 07:35:11 PM
-
Dear all,
Would you please tell me what ferrules (Pin Cord End Terminal Crimp Connector) I should buy for PMDX- 424 Terminal Plug Sets so they wouldn't be too long/short/thick/thin/etc... for the actuall plugs to fit terminal strip sockets? Here's a good example of a diagram I'd love to get (of course not a diagram, but all the necessary dimensions and a place to buy them fast and reliably (if you know) would be VERY, VERY MUCH APPRECIATED!!!
eBay Model number: e1508
and eBay link:
http://goo.gl/rz0ao1
The measurements themselves are attached. THANK YOU!
-
The ferrules that you provided a line for are used with 16 AWG wire are a little
bit large. The ones for 18 AWG should fit into the plugs provided by PMDX. See:
http://www.ebay.com/itm/321656006411?
Remember that these are intended to be crimped onto the wire, not soldered,
so make sure you have a suitable tool.
-
Thank