Show Posts
1
SmartBOB controllers and dedicated accessories / Issue getting spindle to run 424 and 407 connected to YL600
« on: March 03, 2019, 09:27:21 PM »
I have built other cnc system but new to Mach4 cnc.
I cannot get the spindle to run with the current configuration. Was checking if anyone has this VFD it is a Chinese YL600/YL620-A. I can get the spindle to turn when configured from the front panel but when configured with the PDMX-407 I can't get it to spin.
I have the wiring as:
PDMX-407 VFD
RUN > REV
COM > GND
AGND > XGND (digital ground)
AOUT > VI1
AREF > 10V
(Picture 4.jpg has the pinouts on the VFD from the manual)
In the VFD I set P00.01 to 1 and set P07.08 to 3. These values look the same as other Chinese VFD's like this.
In Mach 4 in the plugin config under spindle I enabled PWM and the PMDX-407.
I tried running a s500 but I can't get the spindle to run. Am I missing something here? I have included info from the manual and other pictures of the 407 and the VFD.
Thank you for any help.
I cannot get the spindle to run with the current configuration. Was checking if anyone has this VFD it is a Chinese YL600/YL620-A. I can get the spindle to turn when configured from the front panel but when configured with the PDMX-407 I can't get it to spin.
I have the wiring as:
PDMX-407 VFD
RUN > REV
COM > GND
AGND > XGND (digital ground)
AOUT > VI1
AREF > 10V
(Picture 4.jpg has the pinouts on the VFD from the manual)
In the VFD I set P00.01 to 1 and set P07.08 to 3. These values look the same as other Chinese VFD's like this.
In Mach 4 in the plugin config under spindle I enabled PWM and the PMDX-407.
I tried running a s500 but I can't get the spindle to run. Am I missing something here? I have included info from the manual and other pictures of the 407 and the VFD.
Thank you for any help.