1
Parallel Port breakout boards, motherboards, and dedicated accessories / Re: PMDX 107 PMDX126 controlling VFD Huanyang HY03D023B not functioning with Mach3
« on: November 18, 2019, 05:00:25 PM »
Well, No Reply from Steve???
I sent the following email on 12 November:
"Hello Steve,
I purchased this 107 several years ago as a backup...used the other one for a friends project
and finally got around to installing it on my CNC router, but could not get it to work correctly and
thus, went out to your Forum to get help.
The result was this thread:
https://www.pmdx.com/PMDX-Forums/index.php?topic=607.0
and 12Strings recommended that I ask for an RMA...
It has likely been 4+ years since I purchased it and thus I do not expect any warrenty , but need
to get it working.
Would you be so kind to check this thread and see what you think.
I will need to purchase at least 2 additional 107's also.
If it is something other than the 107 being bad, I would appreciate knowing what might be wrong.
Very Best Regards,
Preston "
Any recommendations on How to Get Steve to answer his email?
Best Regards,
Preston
I sent the following email on 12 November:
"Hello Steve,
I purchased this 107 several years ago as a backup...used the other one for a friends project
and finally got around to installing it on my CNC router, but could not get it to work correctly and
thus, went out to your Forum to get help.
The result was this thread:
https://www.pmdx.com/PMDX-Forums/index.php?topic=607.0
and 12Strings recommended that I ask for an RMA...
It has likely been 4+ years since I purchased it and thus I do not expect any warrenty , but need
to get it working.
Would you be so kind to check this thread and see what you think.
I will need to purchase at least 2 additional 107's also.
If it is something other than the 107 being bad, I would appreciate knowing what might be wrong.
Very Best Regards,
Preston "
Any recommendations on How to Get Steve to answer his email?
Best Regards,
Preston