PMDX Forum
General Category => Parallel Port breakout boards, motherboards, and dedicated accessories => Topic started by: Chuck767 on January 18, 2024, 07:16:32 PM
-
I have a PDMX-122 and Gecko drivers on my Table top TAIG 4 axis milling machine. Using MACH3.
It
-
I have a PDMX- 122 and Gecko drivers on my Table top TAIG 4 axis milling machine. Using MACH3.
WHAT IS WRONG WITH THIS FORUM?
I checked the voltages for the direction pins on the XYZ axis And they each registered 3.4 V and 0.2V when checking the direction pens.
Does this voltage sound acceptable, or is this what is causing my problems ?
Thanks
Chuck
-
NOW IT SEEMS TO BE WORKING ROPERLY