General Category > SmartBOB controllers and dedicated accessories

PMDX 424 Y axis dead

(1/1)

tdfirearms:
Everything was working great. Fired it up to make some parts and have no Y axis movement. Swapped X and Y axis connectors on the 424 and Y axis moves but X axis does not. I swapped the 424 put of another machine I have and everything works fine. Is this circuit failure common on the 424? I don't want to get another 424 if there is a good chance I will have this problem again.

Steve Stallings:
This is not a common failure and you are the first to report this specific failure.

Your unit is covered under warranty. Please contact us about repair.

Navigation

[0] Message Index