Hi all
So I am down to hooking up my proximity sensors
I have 3 wire (brown, black, blue) Inductive sensors NPN NO (detect metal)
I thought this would be pretty straight forward according to page 23 figure 5 NPN Style of the PMDX 126 c manual.
But NOOOO it aint happing, Iam at my wits end trying to figure this out.
It should be pretty easy but when I hook up per fig. 5 the LED lights up on 12 of the BOB, and when I trigger the sensor the led gets brighter on the BOB.If I unhook the black wire the led is ever so faintly still on.
I have the brown wire hooked to the +12U on J12, blue to GND, black to ?12? There is an led on the sensor that lights when I hold it close to metal.
I took a pix of my proximity switch and a wiring diagram of the switch.
Any help or thoughts
Todd