Windows 7 32bit sp1
4gb ram
Mach4hobby build 3233
gecko g540
PDMX 411
Just got everything setup on the 411 and gecko g540 and had one successful job (small one). This morning, I started my second job (a little larger) and all was well for about the first 1 or 2 minutes of the run. Then it just stopped, the enable buttons was flashing, and I got a message saying that the smartBob could not be found. I tried rebooting and rerunning, but when I went into Mach4 I got the message that the autoscan could not find the device. I tried another USB extension cable (both good quality) and another USB port.
The driver being used is below. Is that the right driver?
As it sits now, the red light on the 411 is solid on and the green light is flashing every two seconds, but Mach4 still can not find the device.
I just started two weeks vacation and my whole plan was to get everything working perfectly on my CNC, but ran into this right at the start. Please tell me how to diagnose this
the driver being used is below. Is that the right driver? If not, why would it work fine for a while and then just quite.