1
Parallel Port breakout boards, motherboards, and dedicated accessories / Re: Connecting Clearpath servos to pmdx-126
« on: April 30, 2018, 08:49:47 AM »
Hey Jason,
Not TOO old a thread so hopefully not too much of a dredge. Hopefully you'll see this!
I'm in the same position you were in January!! I have one ClearPath SDSK I want to wire to my Z axis leaving my Gecko's on the other three for now. I am not that sure how to wire the enable AND the HLFB. I can possibly get the step/dir right!!!. Can you explain exactly how you have Enable and HLFB wired to the PMDX-126? I'd appreciate it.
I have a PMDX-126 Rev. C
Tom
Not TOO old a thread so hopefully not too much of a dredge. Hopefully you'll see this!
I'm in the same position you were in January!! I have one ClearPath SDSK I want to wire to my Z axis leaving my Gecko's on the other three for now. I am not that sure how to wire the enable AND the HLFB. I can possibly get the step/dir right!!!. Can you explain exactly how you have Enable and HLFB wired to the PMDX-126? I'd appreciate it.
I have a PMDX-126 Rev. C
Tom