PMDX Forum
General Category => SmartBOB controllers and dedicated accessories => Topic started by: RhoTu on March 15, 2017, 01:36:01 PM
-
Using Mach4 turn, build 3233 and Smart Bob with plugin 49.237 & firmware 56.203
I have posted on the mach4 forum since I don't know whether this is hardware or software related
http://www.machsupport.com/forum/index.php/topic,34458.0.html
Can anyone answer the questions or confirm that they experience the same behavior?
Thanks
RT
-
This topic has resulted in multiple threads on the MachSupport.com forum for Mach4.
Most of the discussion appeared to be about how to operate probing, but I am not
sure if your issue still exists. If it does, please:
1) send us an example of G-code that will demonstrate it
2) send us a packaged profile from your system
3) if possible send us debug logs captured while running your code when the problem
occurs
4) make notes about actual ending locations versus expected locations
Instructions for running with debug logging enabled are here:
http://faq.pmdx.com/content/2/3/en/how-to-capture-a-debug-log-file-and-send-to-pmdx.html
-
Ticket opened with Rob at newfangled, log files sent, screen grab of mdi sent, youtube e video uploaded
https://youtu.be/gwMqFhfHdrc. G31 Creep Mach4 pmdx 411
Out of town until end of week. No access to computer.
Mdi entry
G1 x.3 f.5
G31 x0
Run from cycle start 5 times. Ending error 0.0396
Repeatable
-
I believe you now have everything requested.
-
We think we know what is happening and are trying to unwind the logic
in our plugin to avoid the problem. We may yet ask for a more detailed
log file from our plugin if we cannot prove that we have the quirk that
we saw fixed. Hang in there, this problem is not being ignored.
-
Still hanging in there but am starting to feel like I'm just twisting in the wind.
-
New plugin, version 0.51.252, fixes this problem. thanks.
-
That is great to hear.
Thanks for your patience.