PMDX Forum
General Category => Box level controller products => Topic started by: HDVideo on January 04, 2016, 05:37:51 PM
-
Does the PMDX-340 use one of your breakout board products? What about the drivers? Basically, what's in the box?
Thanks,
Ed
-
The box contains one large PCB with all the electronics including power supply,
drivers, and breakout/interface functions. Other than that, a transformer, power
connectors, a fan, and the E-Stop switch. Internal wiring is minimized as much as
possible.
The motor drivers are short circuit and disconnect/reconnect protected even under
power, so replaceable driver modules are not needed.
If you want to use Mach4 and USB, the PMDX-411 will plug directly on the back of
the PMDX-340.