16
SmartBOB controllers and dedicated accessories / Re: PMDX-411 Mach4 G540 Unable to clear E-Stop
« on: June 01, 2019, 10:46:26 PM »
I'm having the same problem
Mach4 reports
E-stop is in effect! Clear the E-stop condition
My Gecko g540 DB 25 pin out table gives pin 15 as "Fault (input to PC) and the
Main Terminal block pin out has 10 Disable input (e-stop)
I can't seem to find the right combination in Mach4 to accept this.
Mach4 reports
E-stop is in effect! Clear the E-stop condition
My Gecko g540 DB 25 pin out table gives pin 15 as "Fault (input to PC) and the
Main Terminal block pin out has 10 Disable input (e-stop)
I can't seem to find the right combination in Mach4 to accept this.