General Category > Box level controller products
PDMX 340 Setup Help
(1/1)
netbrsr:
I just received the PDMX 340 yesterday, connected KL23H256-30-4B, when I hit the test button I hear the steppers make a humming sound but they don't actually turn.
I looked online and the only documentation I see is the quick start guide and can't seem to get this to work.
for my sw1 all off(up) for my sw2 1 and 2 on(down) the rest off(up)
Stepper Wiring:
Black to A+
Green to A-
Red to B+
Blue to B-
Any idea's?
netbrsr:
I was able to get this working. The problem was setting the axis to test one by one. Once I got past testing, I was able to configure linuxcnc and able to get it running.
Navigation
[0] Message Index
Go to full version