PMDX Forum
General Category => Cables, connectors, switches, contactors, sensors and other items => Topic started by: beerus on February 20, 2016, 09:46:13 AM
-
Whether to work with these sensors AE1-AN-1A - PMDX-424?
Some inductive sensor recommend for PMDX-424? Approximately 25-30$
Thanks
-
The AE1-AN-1A is an NPN sensor from Automation Direct. It will work
fine with the PMDX-424.
For an inductive proximity sensor to work with the PMDX-424, it should
be a 3 wire NPN style sensor. We normally recommend a Normally Open
version because they can be wired in parallel to allow multiple sensors
to share a single pin if needed.
-
Thanks
-
I'm sorry to use their time.
I am trying to read in English.
I got induction sensors AE1-AN-1A. 5 items . How to properly connect to the PMDX 424
Thank
-
I got induction sensors AE1-AN-1A. 5 items . How to properly connect to the PMDX 424
Brown wire to "+12U" terminal on J16 or J17
Blue wire to "GND" terminal on J16 or J17
Black wire to to "isolated input" 1 through 8 on J16 or J17
When you assign the input to a Mach4 input signal (like "Motor 0 --"), make sure to put a green check mark in the "Active Low" column.
Bob