PMDX Forum
General Category => SmartBOB controllers and dedicated accessories => Topic started by: Kane17752 on May 18, 2017, 09:57:50 PM
-
I have the 424 board start my spindle via the relay output on start cycle. If I press the stop button, the spindle stops, but on cycle start, the spindle does not restart. Suggestions on this appreciated.
-
This is normal operation.
Stop is not intended to allow you to resume operation. For that purpose
you should use Feed Hold. You can then use the Spindle ON/OFF button
to stop the spindle to clear chips or whatever, and then use it again to
start the spindle again before you hit Cycle Start to resume.