PMDX Forum

General Category => SmartBOB controllers and dedicated accessories => Topic started by: tdfirearms on September 10, 2022, 03:41:40 PM

Title: PMDX 424 Y axis dead
Post by: tdfirearms on September 10, 2022, 03:41:40 PM

Everything was working great. Fired it up to make some parts and have no Y axis movement. Swapped X and Y axis connectors on the 424 and Y axis moves but X axis does not. I swapped the 424 put of another machine I have and everything works fine. Is this circuit failure common on the 424? I don't want to get another 424 if there is a good chance I will have this problem again.

Title: Re: PMDX 424 Y axis dead
Post by: Steve Stallings on September 26, 2022, 10:00:52 AM

This is not a common failure and you are the first to report this specific failure.

Your unit is covered under warranty. Please contact us about repair.