Messages

16

SmartBOB controllers and dedicated accessories / Re: mach 4 dro is moving but motors are not

« on: October 30, 2015, 04:10:08 PM »

Hi
Thanks for all the help.I checked the wiring and all the step wires are on the even sockets and direction are in the odd sockets.I checked the plug-in config and it matches.As far as to what hardware Im using its the 4-axis kit from automation technologies with kl-4030 drivers and 425oz steppers and c10 board.I also have a e-stop button wired in and that is working because when Im in Mach it shows up with a message that its in E-stop or not depending on button position.As far as the jumpers on the c-10 Its set for pins 2-9 as outputs and the com as +5volts.Not sure if it should be pull up or pull down on the resisters.Also Im not sure if there is anything I need to enter in mach4 config under the inputs or outputs tab.

Thanks
Blair Ballish

17

SmartBOB controllers and dedicated accessories / mach 4 dro is moving but motors are not

« on: October 30, 2015, 12:02:08 AM »

Hi
Another question.Im setting up mach 4 with a pmdx 411 and when I jog an axis the dro on mach shows movement but the motors dont turn.
Any suggestions ??

18

SmartBOB controllers and dedicated accessories / pmdx 411

« on: October 29, 2015, 12:14:31 AM »

Hi
I am having a problem configuring mach4.I  am using win7 64 bit and pmdx 411.When I go into mach4 and select the config tab then the motors tab it wont let me put any info in the boxes at the bottom of screen.Im new to all of this and any help would be great.

Thanks