1
SmartBOB controllers and dedicated accessories / Re: PMDX-411 Mach4 G540 Unable to clear E-Stop
« on: December 18, 2018, 09:00:48 AM »
Thanks 12strings. I appreciate you taking the time to respond.
As it is in most cases in using new h/w & s/w, it was a stupid user error.
I was changing the Input#15 on the Configure/Control/Inputs tab. I needed to scroll down to the E-Stop input and select SmartBobUSB pin 15. Figured it out when I looked carefully at my old Mach3.
The Pin10/EStop label on the SmartBob I/O status confused me too.
As it is in most cases in using new h/w & s/w, it was a stupid user error.
I was changing the Input#15 on the Configure/Control/Inputs tab. I needed to scroll down to the E-Stop input and select SmartBobUSB pin 15. Figured it out when I looked carefully at my old Mach3.
The Pin10/EStop label on the SmartBob I/O status confused me too.