Show Posts
1
General Discussion / FEED RATE NOT CHANGING
« on: July 30, 2019, 05:07:25 PM »
I thought this topic had been covered but I can't find the solution.
I'm running Mach4 Hobby on a PMDX411 and after I upgraded from Mach 3 I can't seem to change my feed rates. Even after I disabled my FRO and RRO sliders I still cannot get my feed rates to change. I've attached my profile.
Joe
I'm running Mach4 Hobby on a PMDX411 and after I upgraded from Mach 3 I can't seem to change my feed rates. Even after I disabled my FRO and RRO sliders I still cannot get my feed rates to change. I've attached my profile.
Joe