PMDX Forum

General Category => SmartBOB controllers and dedicated accessories => Topic started by: hooked on February 20, 2017, 04:02:31 AM

Title: Mach4 Touch Module Error
Post by: hooked on February 20, 2017, 04:02:31 AM

Slowly working through issues with my new build.

Latest Problem:-

Running PMDX-416/MACH4

When I try to do a simple Z axis touch off as soon as the tool makes the contact with the touch plate I get the following error -
"Can't transition from MDI to Stop"

I note another posting with this issue on this forum but there seemed to be no resolution.

Any ideas????

Cheers

Daryl

Title: Re: Mach4 Touch Module Error
Post by: Steve Stallings on February 20, 2017, 08:58:30 PM

Lets consolidate this with your other message in the older thread since
that is where another user has responded. See:

http://www.pmdx.com/PMDX-Forums/index.php?topic=356.0

Title: Re: Mach4 Touch Module Error
Post by: mredski on September 18, 2017, 09:04:47 PM

I have the same problem.

Read the post, did all of the recommended modifications, but still the same, Can't transition from MDI RUNNING to STOP.

I did notice there is an additional error in the History...."PMDX: DEVICE ERROR 'SYSTEM ERROR(7): Motion Calc Underrun"

I have attached the logs and the machine profile.

Title: Re: Mach4 Touch Module Error
Post by: mredski on September 19, 2017, 06:35:51 PM

Added the 2 log files.....

Title: Re: Mach4 Touch Module Error
Post by: Kane17752 on November 17, 2017, 01:28:36 PM

did this ever get resolved.  Having same problems