Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - curt66140

Pages: [1]
1
Never mind, figured it out.

2
I just got my PMDX-424 board and I need to translate the motor connections from my old controller board to the step\dir pins on the 424 board.  The old controller used a,A and b,B plus common, I need to take this to the 424 board.  My motors are 8 wire unipolar that are wired as 4 wire bipolar.  Thanks for any help.
Curt

Pages: [1]