PMDX Forum

General Category => SmartBOB controllers and dedicated accessories => Topic started by: SolarImages on May 24, 2015, 06:06:10 PM

Title: Need Advice on what Bob to get.
Post by: SolarImages on May 24, 2015, 06:06:10 PM

I have a old Dyna CNC machine i use for routing wood. It currently uses gecko 320's, 3 of them to run 3 servo's with a torch height controller in line using two parallel ports. I would like to remove the THC and move to a Ethernet control instead of a parallel port. So what board would be best here? i was thinking PMDX 126 with a 107 on it? If this is a good route what voltage do i need to supply the board with? Thank you for any help in this!

Title: Re: Need Advice on what Bob to get.
Post by: Bob at PMDX on May 31, 2015, 11:47:03 PM

Sorry, this slipped though.  The PMDX-126/107 combo needs only 120 or 240VAC.  They generate all other necessary voltages, including isolated ones, on-board.  You can always download the manuals for our boards to see how to connect them and what their power requirements are.  See the individual product pages, or the current versions of all of our manuals are located here:
http://pmdx.com/Manuals

For further discussion, see your other thread here :
http://www.pmdx.com/PMDX-Forums/index.php?topic=117

Bob