PMDX Forum

General Category => SmartBOB controllers and dedicated accessories => Topic started by: madiaz91911 on October 30, 2015, 04:20:05 PM

Title: E-Stop does not work
Post by: madiaz91911 on October 30, 2015, 04:20:05 PM

I connected an e-stop to the 422 board. Connected switch to pin 10 and then the other side of the switch to the "GND".  This configuration does not work. Anything else I need to do? I also see an e-stop on the J10 side. That one has a jumper on it. What that doing?

Title: Re: E-Stop does not work
Post by: Steve Stallings on October 30, 2015, 04:35:17 PM

The jumper is installed at the factory so that the board will run if you do not connect an E-Stop switch.

When you do connect a normally closed E-Stop switch, you must remove the jumper in order for it to work.