PMDX Forum

General Category => SmartBOB controllers and dedicated accessories => Topic started by: MitchB on November 02, 2015, 04:04:17 PM

Title: Charge Pump pin in the Mach configuration changes on its own
Post by: MitchB on November 02, 2015, 04:04:17 PM

If I perform the following steps, the charge pump pin number in the Mach output configuration changes from Pin 1 to Pin 17.  This is with XP Pro and Mach 4.2.0.2763 and PMDX-411 v0.31.147

1. Start with charge pump assigned to pin 1 and enable Mach.
2. Enter plug in configuration and change something - like spindle assertion level.
3. Exit configuration screen.
4. Charge pump pin has now changed to pin 17 in the Mach configuration screen

I don't know if this is a Mach or a plug-in issue.

Title: Re: Charge Pump pin in the Mach configuration changes on its own
Post by: Bob at PMDX on November 02, 2015, 05:11:33 PM

Thank you for posting the steps to reproduce this.  Despite my response in your other thread, I have indeed replicated this problem.  Now I gotta go figure out why.  Stay tuned.

Bob

Title: Re: Charge Pump pin in the Mach configuration changes on its own
Post by: Bob at PMDX on November 03, 2015, 04:39:56 PM

Found the problem.  Look for a new plug-in release probably/hopefully tomorrow (Nov 4th).