PMDX Forum

General Category => SmartBOB controllers and dedicated accessories => Topic started by: curt66140 on August 03, 2017, 02:24:09 AM

Title: wiring a unipolar stepper motor to the PMDX-424
Post by: curt66140 on August 03, 2017, 02:24:09 AM

I just got my PMDX-424 board and I need to translate the motor connections from my old controller board to the step\dir pins on the 424 board.  The old controller used a,A and b,B plus common, I need to take this to the 424 board.  My motors are 8 wire unipolar that are wired as 4 wire bipolar.  Thanks for any help.
Curt

Title: Re: wiring a unipolar stepper motor to the PMDX-424
Post by: curt66140 on August 03, 2017, 11:32:16 PM

Never mind, figured it out.