PMDX Forum

General Category => General Discussion => Topic started by: Tripp on February 20, 2016, 10:49:16 AM

Title: Motion Controller Mach3
Post by: Tripp on February 20, 2016, 10:49:16 AM

Hello PMDX,
I notice your 410, 422 and 424 only specify "for use with Mach4".
Are these, or do you have motion controllers that are compatible w/Mach3 ?

Thanks

Title: Re: Motion Controller Mach3
Post by: Steve Stallings on February 20, 2016, 12:51:39 PM

All of the SmartBOB series controllers are designed for Mach4. They do
not support Mach3.

Our other products that are parallel port compatible can be used with
Mach3. This includes our most popular board, the PMDX-126.