PMDX Forum
General Category => Cables, connectors, switches, contactors, sensors and other items => Topic started by: hernandd58 on April 11, 2016, 07:28:39 PM
-
What screw terminal do I use for a touch probe for my Z motor. Any suggestions.
Thanks
-
Sorry it for a PMDX 424 board
-
In general, any of the PMDX-424's inputs will work. However, I would recommend using one of the 8 isolated inputs on connectors J16 and J17 (i.e. SmartBOB Input1 through Input8). These provide extra protection "just in case", since the touch probe wiring goes over to the machine instead of, say, switches on a panel.
Bob