PMDX Forum

General Category => Generic Spindle interfaces, I/O boards, Misc boards and panels => Topic started by: lab auto man on April 25, 2019, 09:17:16 PM

Title: Setting up my Haunyang inverter GT-4R0G-2 to run a 3.2kw spindle
Post by: lab auto man on April 25, 2019, 09:17:16 PM
Ok. I have been able to get the spindle wired to the inverter and the inverter powered up. I set the motor parameters p2.01 to p2.05 and performed the auto tune!  I am just trying to get it run via the front of the inverter before interfacing it to Mach 4. 
p0.00  = 1
p0.01  = 0
P0.02   =0
P0.03 = 400
P0.04 = 400
P0.05 = 50
P0.06 = 50
P0.07 = 0
P0.08 = 0
P0.09 = 0
P0.10 = 0
P0.11 = 6   5 or less cause auto tune to fail
P0.12 = 6   5 or less cause auto tune to fail

I removed the jumper between pins 3 and 4 of J1 so that it is set for control via front panel.   The spindle hums and may turn a little but something is not correct.  Any Ideas?
Thaanks,
Todd
Title: Re: Setting up my Haunyang inverter GT-4R0G-2 to run a 3.2kw spindle
Post by: lab auto man on April 26, 2019, 06:50:00 PM
Got it spinning via the front control panel.  Had to change P0.00 to 0   Would not work in Mode 1, senseless vector control?  Also had to set p0.07 to 1

Now to get it working with Mach 4.  Will take a while.  Have to order water pump and mounting bracket.  Will post when (if) I need more help.