PMDX Forum

General Category => Parallel Port breakout boards, motherboards, and dedicated accessories => Topic started by: JohnDH on April 23, 2020, 01:15:09 PM

Title: Simple wire connections to K1 relay on PMDX-126
Post by: JohnDH on April 23, 2020, 01:15:09 PM
Very novice here. Just want to connect router to K1 relay. Not concerned about software settings. Just want to know how to physically connect the router to the relay. Which wires go where? Hot, neutral, ground?
Title: Re: Simple wire connections to K1 relay on PMDX-126
Post by: Steve Stallings on April 23, 2020, 08:11:14 PM
The relay connections on the PMDX-126 are for just the contacts of the relay, no power from the board comes out of the connector. You wire it up as if it was a switch controlling external power.