Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Doddjn

Pages: [1]
1
After hooking up my Sherline (KBIC) DC motor controller, I get the following message. "Spindle speed capped by current range". Any ideas. Note the spindle turns on and off and when the spindle is on I get 6.6 volts between Aref and Agnd terminals on the 407 board. I have the Mach4 set on line 0 to min .05 and Max 1.00 in the config - spindle tab

Regards - John

Pages: [1]