Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Tripp

Pages: [1]
Hi folks,
I've read all I could find regarding your threading/sync methods.
Can you tell me how you handle the pullout of the tool at the end of the thread ?
Does the Z maintain the constant feed rate during the retraction ?

General Discussion / Motion Controller Mach3
« on: February 20, 2016, 10:49:16 AM »
Hello PMDX,
I notice your 410, 422 and 424 only specify "for use with Mach4".
Are these, or do you have motion controllers that are compatible w/Mach3 ?


Pages: [1]