1
General Discussion / Starting from scratch
« on: July 22, 2016, 10:56:59 AM »
I've used Sherline manual equipment for several years. To have the ability to make multiple duplicates, I'd like to move into CNC equipment. My previous Sherline equipment was damaged in a fire so I'm literally starting from scratch.
I'm considering the following equipment:
A 4400 lathe
A 5400 mill
a 2000 mill
a Sherline rotary table.
Source steppers from another source
a PDMX board to be determined
I'm unsure what computers to buy. I'm guessing I'll need one for each machine to work reliably.
Fuison 360 software
I'm I off base? Is this a workable package?
Thanks,
Mike
I'm considering the following equipment:
A 4400 lathe
A 5400 mill
a 2000 mill
a Sherline rotary table.
Source steppers from another source
a PDMX board to be determined
I'm unsure what computers to buy. I'm guessing I'll need one for each machine to work reliably.
Fuison 360 software
I'm I off base? Is this a workable package?
Thanks,
Mike