Show Posts
1
SmartBOB controllers and dedicated accessories / Noob. Hooking up PMDX 424. Cant get motors to spin
« on: September 07, 2019, 07:46:54 PM »
Hello,
Complete beginner when it comes to CNC. Trying to set up] two NEMA 23s, two DM542T, and PDMX 424.
I wired everything up and fired up Mach 4 and I tried jogging the motors but nothing is moving. I followed the start up guide in the PMDX 424 manual.
Downloaded smartBOB plug in and can see the DRO's moving when I use keyboard but no motor movement.
Attached is my wiring set up and a LUA error I recieve. What is LUA?
Any input is appreciated. Thanks
Complete beginner when it comes to CNC. Trying to set up] two NEMA 23s, two DM542T, and PDMX 424.
I wired everything up and fired up Mach 4 and I tried jogging the motors but nothing is moving. I followed the start up guide in the PMDX 424 manual.
Downloaded smartBOB plug in and can see the DRO's moving when I use keyboard but no motor movement.
Attached is my wiring set up and a LUA error I recieve. What is LUA?
Any input is appreciated. Thanks