Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Xyetti

Pages: [1]
1
Hello, I have connected my ethernet smooth stepper to my PMDX 126 and my PMDX 126 to my PMDX 134 and have connected the first axis motor X. I configured Mach 4 from videos and followed the PMDX 134 installation manual.
Upon powering it up, I then go to jog the motor and it doesn't respond. It is powered on as I have a power light on the PMDX 134 and the Nema 34 is on because I cannot rotate the shaft. It won't jog either way. In Mach 4 I think I have the right pin outputs eg port 1 pin 2 goes to X step, Port 1 pin 3 goes to X Dir.
Maybe someone with the same setup can share how they configured it. Thanks in advance

Pages: [1]