1
Cables, connectors, switches, contactors, sensors and other items / PMDX-126 - ESS - VFD Mach 4 Spindle Setup
« on: June 13, 2021, 06:11:27 PM »
Hey All,
I am moving from Mach3 to March4 and swapping out the stock controller for a PMDX-126 and ESS. My limit switches and motors are working, now it is time for the spindle. I would like to use the onboard relays to denote direction. I believe my wiring is correct, but I need some help with the configuration. Looking at the setup below, can you please tell me how to configure the ESS and Mach4?
JP1 - Multimode
K1 Com -> VFD - DCM
K1 N/O -> VFD - M1
JP2 - Multimode
K2 Com -> VFD - DCM
K2 N/O -> VFD - M2
J6 - 1 = Port 1 Pin 1 -> VFD - ACM
J6 - 16 = Port 1 Pin 16 -> VFD - AVI
I am moving from Mach3 to March4 and swapping out the stock controller for a PMDX-126 and ESS. My limit switches and motors are working, now it is time for the spindle. I would like to use the onboard relays to denote direction. I believe my wiring is correct, but I need some help with the configuration. Looking at the setup below, can you please tell me how to configure the ESS and Mach4?
JP1 - Multimode
K1 Com -> VFD - DCM
K1 N/O -> VFD - M1
JP2 - Multimode
K2 Com -> VFD - DCM
K2 N/O -> VFD - M2
J6 - 1 = Port 1 Pin 1 -> VFD - ACM
J6 - 16 = Port 1 Pin 16 -> VFD - AVI