1
SmartBOB controllers and dedicated accessories / Re: No synchronized position from motion planner
« on: January 19, 2023, 06:40:43 PM »
Hello,
I just got this error at start up. I was able to get rid of it by disabling and then enabling the PMDX Plugin.
In Mach4 under Configure select Control. Select the Plugins tab, to disable the PMDX by clicking on the green arrow.
A message will appear that a restart is required, click on ok. Do not restart. Click on the red x to enable the PMDX.
Press ok at the bottom of the window.
Hopefully this works for someone else.
I just got this error at start up. I was able to get rid of it by disabling and then enabling the PMDX Plugin.
In Mach4 under Configure select Control. Select the Plugins tab, to disable the PMDX by clicking on the green arrow.
A message will appear that a restart is required, click on ok. Do not restart. Click on the red x to enable the PMDX.
Press ok at the bottom of the window.
Hopefully this works for someone else.