1
Generic Spindle interfaces, I/O boards, Misc boards and panels / pmdx-107 test
« on: November 01, 2020, 12:04:51 PM »
I have a PMDX-107 that doesn't seem to be sending anything to the J1 connector. All the lights flash like they should in test mode, but when I connected it to my motor control adjusting the pot doesn't change the motor speed. I am also using the Run/Com ports to flip a PMDX-ContactorMD20-120 on. I tested the PMDX-ContactorMD20-120 using 120v and it does flip but not when its connected to the PMDX-107. I checked between Run and Com using a multimeter and there isn't anything when its in test mode. I also checked between Aout and Agnd am I doing something wrong or is the board bad?