Author Topic: Bridgeport CNC  (Read 10873 times)

apayne

  • Posts: 11
    • View Profile
Re: Bridgeport CNC
« Reply #15 on: March 09, 2016, 06:43:55 PM »
So I looked up the motors and it looks as if the Prolight uses 6 connections and the Orac uses 8. 

Aaron

Steve Stallings

  • Administrator
  • Posts: 527
  • www.PMDX.com/Images/Avatar120.jpg
    • View Profile
Re: Bridgeport CNC
« Reply #16 on: March 09, 2016, 08:12:12 PM »
OK, I cannot quite read the labels on your motors. Could you send
me a higher resolution picture of them. No need to post them here,
just send them direct by email.
Steve Stallings
www.PMDX.com

apayne

  • Posts: 11
    • View Profile
Re: Bridgeport CNC
« Reply #17 on: March 10, 2016, 10:32:06 AM »
Not sure what happened with the last two posts?  but


The Prolight has 6 connections according to the motor data sheet and needs 2.9 amps to run.

The Orac has 8 Leads and uses 3.1 amps.

Aaron

Steve Stallings

  • Administrator
  • Posts: 527
  • www.PMDX.com/Images/Avatar120.jpg
    • View Profile
Re: Bridgeport CNC
« Reply #18 on: March 14, 2016, 10:00:53 AM »
It should be possible to use the PMDX-340 with both of these machines.

When the time comes, please provide readable photos of the motor
labels and we will offer suggestions for wiring.
Steve Stallings
www.PMDX.com