Author Topic: SmartBOB probes on encoder inputs  (Read 1810 times)

Tony Bullard

  • Posts: 5
    • View Profile
SmartBOB probes on encoder inputs
« on: December 06, 2020, 03:04:24 PM »
How many probes are supported on the plugin? May I use inputs from another plugin?
Thanks for any help.

12strings

  • Posts: 278
    • View Profile
Re: SmartBOB probes on encoder inputs
« Reply #1 on: December 07, 2020, 12:24:36 AM »
I believe the PMDX plug-in supports only one probe and it must be mapped to the input signal Mach4 calls "Probe" (and G31), not any of the "ProbeX" where "X" is a number (and the corresponding G31.X) .  See the PMDX plug-in release notes section 9, "Probing Features and Restrictions".  I'm pretty sure the probe can be connected to any input pin on whichever SmartBOB you have, but it must be an input on the SmartBOB.  It cannot be on any other board.  That is because the probing motion happens IN the SmartBOB, not in Mach4, and the SmartBOB can only see signals physically attached to it.

Tony Bullard

  • Posts: 5
    • View Profile
Re: SmartBOB probes on encoder inputs
« Reply #2 on: December 07, 2020, 08:10:39 AM »
Thank you. The PMDX plug-in release notes section 9, "Probing Features and Restrictions" explained this very well. I appreciate your help.