Author Topic: M62P1/M63P1 on PMDX416  (Read 614 times)

Rubes

  • Posts: 5
    • View Profile
M62P1/M63P1 on PMDX416
« on: November 28, 2019, 06:47:08 PM »
Does the PMDX416 support the M62Px/M62Px commands in Mach4? from what I gather these used to be M10Px and M11Px
I am trying to turn a laser on/off and understand this is a faster/better way to do it to not get the "bloom" at the start of a line.

found this old thread that used macros to enable an output with M10
https://www.pmdx.com/PMDX-Forums/index.php?topic=217.msg826#msg826
wouldnt running a macro be slower than just using M3/M5?

Im useing:
SmartBOB Plugin version: 0.53.263
SmartBOB firmware version: 0.60.208
SmartBOB bootloader version: 1.13.73

Thanx

12strings

  • Posts: 182
    • View Profile
Re: M62P1/M63P1 on PMDX416
« Reply #1 on: November 30, 2019, 10:33:58 AM »
If you look in the plug-in release notes, it says M62/63 have been supported since version 0.38 (2016).