Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jbenson

Pages: [1]
1
General Discussion / Gecko drivers
« on: December 19, 2017, 05:32:25 PM »
Newbe here,\\ Question: do I need to use Gecko Drivers with the PMDX-126 or can I use any kind of driver? The only reason I ask is because in the manual they reference the Gecho. I have a Micro Step DMA860H Driver. Also is the PC+5V referenced connectors J1 - J4 coming from the breaker boards power supply or from the PC.  I appreciate any help. Thanks

2
Hello all,

 I just bought this China CNC which runs on NCStudio. It works well enough but not as well as Mach3. I really don't want to screw up my machine so I was hoping I can get someone to help me wire it up to the PMDX-126 board. I am including a schematic that I drew up in Visio (since China didn't include).

I would appreciate any help

Pages: [1]